How to install safe2dock
Inflatable Dock Fenders
The guide below will help you install all sizes of safe2dock inflatable dock fenders.
Only 3 tools are required for installation including a pen, tape measure and impact driver with + bit.
Fenders are designed to be secured permanently in position.
Diameters: 350 mm (14") and 450mm (18").
Lengths: 1000mm (39") x 1500mm (59"), 3000mm (118"), 3000mm (236").
Colours: Light Grey / Black.
Fabrics: PVC / TPU.​
Tools required for installation
​​
TIME: To install 3-4 dock fenders typically takes 30 minutes.
TOOLS: Tape measure and pen. Screw driver / impact driver .​
Follow these 6 easy steps on How to tie a boat fender to the dock.
Step 1
​​
How to Install safe2dock Inflatable Boat Fenders:
​
Lay the fender flat – Position it on its side with D-rings facing the dock.​
Step 2
Step 3
Attach swivel shackles – Secure them to the D-rings for flexibility.​
Screw in half saddles – Align with D-rings and screw 60-65mm from the edge.​
Step 4
Step 5
Step 6
Flip the fender over – Release the inflation valve and secure the plug.
Attach the shackle pin – Thread it through the half saddle, ensuring it faces away from the tube.​
Inflate to 2 PSI – Use an electric or foot pump until firm.​
Pro Tip: Attach a safety line and tie to dock.
Don't Take our word for it! Here are some Reviews from our customers!
Tim Hansen
“We all know about windy docking.
I hit the side fender hard at about 15 degrees after my bow was pushed around,
even after using the thruster, simply bounced off."
Bennett Medary
“It was very easy to install these and Hilton made sure that I
had plenty of spare hardware to attach them to the dock.
They were great and I actually did find myself resting against them
sometimes when facing a stiff westerly! "
Becca Mintern
"...I put it back into reverse and promptly bounced off
the newly installed safe2dock fender. Truly a real Dock Bumper.
Just as well, the duckboard would have hit the concrete
pontoon supporting the walkway. Saved my rear end!"
